![]() Here are the files if you wish to use my design. This fits nicely in my checkbook and I can continue to keep track of my account. I then folded the 5 sheets in half and put 2 staples in the crease. Scissors or an X-Acto knife would work but a paper cutter is easier to use. I used a paper cutter to cut very closely around the grid. If you print it wrong, you’ll figure it out when you put everything together. ![]() This allows you to flip through the register. This left me with 5 sheets with the register printed on both sides but turned upside down on one side. Then I flipped the paper over and turned it around so that the top became the bottom and the front became the back and then printed 5 more copies. ![]() Then I printed out 5 copies at 100% scale making sure it was centered both horizontally and vertically. I just measured and copied my old one and made a few minor changes based on my preferences. It is not difficult to construct a check register using a spreadsheet program. Then it dawned on me that I could easily make one from a spreadsheet. I went to several stores trying to buy a new register but I could not find any. You usually get a new one when you order new checks but I won’t need to order checks for a while and I didn’t have an extra register laying. Recently I used up all the lines in my check register for my checking account.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |